Tate press
Extensión con mancuernas hacia la cara.
Introduction & biomechanics
Extensión con mancuernas hacia la cara.
Movement pattern: Horizontal or vertical push pattern. Creates anterior chain tension with active scapular stabilization.
Equipment: Mancuernas, banco · Difficulty: intermediate · Stress type: mechanical
This exercise is effective for hypertrophy when executed with full ROM, controlled tempo and RIR 1-2. Adjust load to maintain technique across all reps.
Step-by-step execution
Starting position / Setup
- Set up Tate press with stable footing and a braced core.
- Align joints (wrist-elbow-shoulder or hip-knee-ankle depending on pattern).
- Grip/adjust equipment: Mancuernas, banco.
- Retract scapulae if applicable; maintain neutral spine.
- Take a deep breath into the diaphragm before initiating the first rep.
Concentric phase (push/pull/lift)
Drive the movement with intent on Triceps (lateral head) (tempo 1-0-1-0). Avoid momentum from surrounding muscles. Lock out or peak contraction without losing joint alignment.
Eccentric phase (return)
Lower under control for 2-3 seconds to maximize mechanical tension. Stop before form breakdown; maintain scapular and spinal position throughout.
Breathing pattern
- Compound lifts: Inhale during setup/brace, exhale through the sticking point on concentric, inhale again at the top or before the next rep.
- Isolation: Exhale on exertion (concentric), inhale on eccentric.
- Avoid prolonged Valsalva unless lifting near-max loads with experience.
Muscles worked
- Agonist (primary): Triceps (lateral head)
- Synergists: —
- Auxiliary / support: Forearms
- Stabilizers: Rectus abdominis / Core
Common mistakes & injury prevention
- Swinging torso to move the weight (momentum) — Correct by reducing load and focusing on controlled tempo.
- Elbows drifting from the movement plane — Correct by reducing load and focusing on controlled tempo.
- Not controlling the eccentric phase (free fall) — Correct by reducing load and focusing on controlled tempo.
- Using excessive load that limits full ROM — Correct by reducing load and focusing on controlled tempo.
Variants & adaptations
- Hammer curl (brachialis)
- Triceps pushdown (isolation)
- Close-grip bench (compound triceps)
- Preacher curl (strict form)
By equipment: Swap to barbell or cables for variety.
Programming tips
- Sets/reps: 3-4 × 6-12 (compounds) or 3-4 × 10-20 (isolation), RIR 1-2.
- Rest: 90-180 s compounds, 60-90 s isolation.
- Frequency: 2×/week per muscle group with adequate recovery.
- Progression: Add reps first, then load (2.5-5 kg) when hitting top of rep range.
Introduction & biomechanics
Extensión con mancuernas hacia la cara.
Movement pattern: Horizontal or vertical push pattern. Creates anterior chain tension with active scapular stabilization.
Equipment: Mancuernas, banco · Difficulty: intermediate · Stress type: mechanical
This exercise is effective for hypertrophy when executed with full ROM, controlled tempo and RIR 1-2. Adjust load to maintain technique across all reps.
Step-by-step execution
Starting position / Setup
- Set up Tate press with stable footing and a braced core.
- Align joints (wrist-elbow-shoulder or hip-knee-ankle depending on pattern).
- Grip/adjust equipment: Mancuernas, banco.
- Retract scapulae if applicable; maintain neutral spine.
- Take a deep breath into the diaphragm before initiating the first rep.
Concentric phase (push/pull/lift)
Drive the movement with intent on Triceps (lateral head) (tempo 1-0-1-0). Avoid momentum from surrounding muscles. Lock out or peak contraction without losing joint alignment.
Eccentric phase (return)
Lower under control for 2-3 seconds to maximize mechanical tension. Stop before form breakdown; maintain scapular and spinal position throughout.
Breathing pattern
- Compound lifts: Inhale during setup/brace, exhale through the sticking point on concentric, inhale again at the top or before the next rep.
- Isolation: Exhale on exertion (concentric), inhale on eccentric.
- Avoid prolonged Valsalva unless lifting near-max loads with experience.
Muscles worked
- Agonist (primary): Triceps (lateral head)
- Synergists: —
- Auxiliary / support: Forearms
- Stabilizers: Rectus abdominis / Core
Common mistakes & injury prevention
- Swinging torso to move the weight (momentum) — Correct by reducing load and focusing on controlled tempo.
- Elbows drifting from the movement plane — Correct by reducing load and focusing on controlled tempo.
- Not controlling the eccentric phase (free fall) — Correct by reducing load and focusing on controlled tempo.
- Using excessive load that limits full ROM — Correct by reducing load and focusing on controlled tempo.
Variants & adaptations
- Hammer curl (brachialis)
- Triceps pushdown (isolation)
- Close-grip bench (compound triceps)
- Preacher curl (strict form)
By equipment: Swap to barbell or cables for variety.
Programming tips
- Sets/reps: 3-4 × 6-12 (compounds) or 3-4 × 10-20 (isolation), RIR 1-2.
- Rest: 90-180 s compounds, 60-90 s isolation.
- Frequency: 2×/week per muscle group with adequate recovery.
- Progression: Add reps first, then load (2.5-5 kg) when hitting top of rep range.
Recommended variants
- •Hammer curl (brachialis)
- •Triceps pushdown (isolation)
- •Close-grip bench (compound triceps)
- •Preacher curl (strict form)